Electronics Lab-1

Electronic Devices Lab

In this Lab Students are able to learn how to

1. Understand characteristics of Diodes
2. Plot the characteristics of BJT in different configurations
3. Record the parameters of BJT and FET amplifiers
4. Understand biasing techniques of BJT
5. Use the SPICE software for simulating electronic circuits

Analog  Electronic Circuits  Lab

In this Lab Students are able to learn how to

1. Calculate gain and bandwidth of BJT, FET
2. Study Multivibrator circuits
3. Study oscillator circuits
4. Demonstrate filter circuits
5. Demonstrate power amplifier and Op-Amp. Circuits

Electronics Lab-2

 

Electronic Workshop and Simulation Lab

In this Lab Students are able to learn how to

1. Use the basic electronic components and design circuits
2. Verify various parameters of the circuits by applying theorems
3. Understand the pin configuration of ICs and verify the operation of basic gates
4. Design and verify the combinational and logic circuits

 

Basic Electronics Lab

In this Lab Students are able to learn how to

1. Understand characteristics of Diodes
2. Plot the characteristics of BJT in different configurations
3. Record the parameters of BJT and FET amplifiers
4. Understand biasing techniques of BJT

 

Pulse digital and Integrated Circuit Lab

In this Lab Students are able to learn how to

1. Design and analyze linear and non-linear wave shaping circuits
2. Design and analyze clipping and clamping circuits
3. Design and analyze multivibrator circuits
4. Design and analyze Schmitt trigger circuit
5. Verify the characteristics of  TTL & CMOS circuits

Communication Lab /Microwave Engineering Lab

• Communication  Lab

In this Lab Students are able to learn how to

1. Understand and simulate modulation and demodulation of AM and FM
2. Construct pre-emphasis and de-emphasis at the transmitter and receiver respectively
3. Understand and simulate the PAM, PWM & PPM circuits
4. Understand baseband transmission (i.e., PCM, DPCM, DM, and ADM) generation and detection
5. Understand error detection and correction

 

• Microwave  Engineering  Lab

 In this Lab Students are able to learn how to

1. Analyze frequency, Wave length, SWR and Impedance for Reflex Klystron Oscillator by using its equation
2. Evaluate of mode characteristics of Reflex klystron and V-I Characteristics of Gunn diode
3. Analyze of the characteristics of Circulator, Isolator, Directional Coupler, Tees like (Magic tee, E & H plane tees) using the Scattering parameters
4. Generate the Radiation pattern of different antennas like Yagi-Uda and Horn Antenna and measure the gain of the antennas
5. Familiarize with the EM simulation software

ED & AEC LAB

ED & AEC LAB

MPMC LAB

MPMC LAB

SSP & VLSI LAB

SSP & VLSI LAB

EW & IC LAB

EW & IC LAB

COM & MWE LAB

COM & MWE LAB